Beverage Air DW64HC-S Bottle Cooler

Bottle Cooler, flat top, 65"W x 26-1/2"D x 33-3/4"H, 18.5 cu. ft., (2) sliding lids, (4) adjustable epoxy coated wire dividers, case capacity: 25-1/4 cases (12 oz. bottles) or 34-3/4 cases (12 oz. cans), deep well design, bottle cap opener & cap catcher, galvanized interior, stainless steel top & exterior, self-contained refrigeration system, R290 Hydrocarbon refrigerant, 1/4 HP, cULus, UL EPH Classified, UL-Sanitation, Made in USA

Does your establishment need to quickly cool and store bottled or canned beverages? The DW64HC-S Bottle Cooler from Beverage Air is a great solution that can be used as a primary chiller or to pre-cool beverages before putting them into a merchandizer or pass-thru unit. This unit can hold up to 34 ¾ cases of 12 oz. cans or 25 ¼ cases of 12 oz. bottles in its 18.5 cu. ft. interior.

With two sliding lids made from stainless steel providing effortless access to bottles or cans and a stainless steel countertop complete with glass stops, this unit is a one-stop solution for conveniently serving beverages. To quickly serve bottled drinks, this unit comes with a bottle cap lifter and catcher that makes the process one fluid motion without workers needing to worry about bottle caps falling on the floor. Four epoxy-coated dividers are included to keep bottles and cans organized. The interior is kept nice and cool from 36°F to 40°F by high RPM cooling fans.

Fast and efficient cooling is provided by the self-contained refrigeration system with a ¼ HP compressor that provides 1702 BTU/hr of cooling. The fully electronic controls in this unit monitor and maintain the temperature inside while minimizing power draw. An epoxy-coated evaporator coil will make sure reliable refrigeration with minimal maintenance can be provided for years to come. Environmentally-friendly R290 refrigerant is used for its reduced contribution to climate change. This hydrocarbon refrigerant meets all environmental regulations while proving safe sustainable cooling. The defrost system is non-electric to keep the unit running efficiently while keeping downtime to a minimum.

Power is supplied to the unit with a factory wired 8-foot power cord with a NEMA 5-15P plug set to connect it to a standard outlet that provides 115v/60/1-ph power at 2.5 amps.