ACCUREX Non-Filtered, Heat and Fume

Description

ACCUREX XO Description

Provide Accurex Exhaust Hood Model XO as shown on plans and in accordance with the following
specification:
Heat and Fume hood(s) shall be of the Type II, exhaust only canopy.
The hood(s) shall be constructed of a minimum of 18 gauge 400 series stainless steel (300 series
optional). The hood(s) shall be constructed using the standing seam method for optimum strength and
with a Performance Enhancing Lip (PEL) to improve capture efficiency by turning air back into the hood.
All seams, joints and penetrations of the hood enclosure shall be welded and/or liquid tight. Lighter
material gauges, alternate material types and finishes are not acceptable.
Optional, vapor proof, U.L. Listed incandescent light fixtures (fluorescent and LED optional, restrictions
apply) shall be pre-wired to a junction box situated at the top of the hood for field connection. Wiring shall
conform to the requirements of the NFPA® 70.
The canopy hood(s) shall be constructed by Accurex. They shall be built in accordance with the NFPA®96, UMC, and bear the NSF Seal of Approval.
Due to continuous research Accurex reserves the right to change specifications without notice 
Close Description