ACCUREX Baffle Filter Backshelf Hood, Exhaust Only

Provide Accurex Exhaust Hood Model XBEP as shown on plans and in accordance with the following 

specification:

Kitchen Ventilation hood(s) shall be of the Type I, exhaust only wall low proximity. The hood(s) shall be 

U.L. 710 Listed without a fire damper (with optional) for 450°F or 600°F rated cooking appliances. Please

visit www.ul.com for U.L. 710 listing for performance and size options. Make-up air shall be independently 

provided.

The hood(s) exterior shall be constructed of a minimum of 18 gauge 400 series stainless steel (300 series 

optional). The hood(s) shall be constructed using the standing seam method for optimum strength and 

with a Performance Enhancing Lip (PEL) to improve capture efficiency by turning air back into the hood. 

An integral 3-inch air space is provided to meet NFPA® 96 clearance requirements against limited 

combustible walls. Integral 3-inch air space may be omitted for non-combustible construction. All seams,

joints and penetrations of the hood enclosure shall be welded and/or liquid tight. Lighter material gauges, 

alternate material types and finishes are not acceptable. All unexposed interior surfaces shall be 

constructed of a minimum 18-gauge corrosion resistant steel including, but not limited to ducts, plenum, 

and brackets.

The hood(s) shall include a filter housing constructed of the same material as the hood. The filters shall 

be stainless steel baffle type (non-stick coating optional), U.L. 1046 Classified, and in sufficient number 

and size to ensure optimum performance. The filter housing shall terminate in a pitched, full length grease 

trough which shall drain into a removable grease container. These filters shall have a grease removal 

efficiency of 28% at 8 microns (16% from 3-10 microns) and static pressure drop of 0.5-0.6 inWC. 

Optional Vapor proof, U.L. Listed incandescent light fixtures (restrictions apply) shall be pre-wired to a 

junction box located at the top of the hood for field connection. Wiring shall conform to the requirements 

of the NFPA® 70.