Everest Refrigeration ETBR2-D4 47.5'' 2 Section Undercounter Refrigerator with 4 Drawers and Side / Rear Breathing Compressor

Everest Refrigeration ETBR2-D4 Description

Drawered Undercounter/Worktop Refrigerator, two-section, 47-1/2"W, 14.0 cu. ft. capacity, self-contained rear mounted refrigeration, 16 gauge stainless steel worktop, (4) heavy duty drawers, digital controls with LED display, auto defrost, front air breathing, pressure relief port, stainless steel interior, stainless steel front & sides, galvanized steel bottom & rear, (4) 5" swivel casters (2 locking), R290 Hydrocarbon refrigerant, 1/5 HP, 115v/60/1-ph, 2.6 amps, cord, NEMA 5-15P, NSF, cETLus, ETL-Sanitation (drawer pans not included)

• Front air breathing for flexibility in installation.
• Pre-wired and ready to plug, 115V/60Hz/1Ph, NEMA 5-15P.
• Full-length air duct system ensures optimal circulation of cold air.
• Large capacity, corrosion-resistant condenser and evaporator coils.
• Time-initiated and temperature-terminated auto defrost cycle for seamless operation.
• Pressure relief devices allow smooth access to cabinet interior when reopening doors.
• Electronically commutated (ECM) fan motors achieve rapid cooling with less energy consumption.
• Self-maintaining, energy-efficient condensate drain pan requires no external drains or electric heaters.
• High performance, auto-reverse condenser fan motor supports compressor ventilation and condenser coil cleaning. Refer to owner’s manual for full maintenance instructions.
• Back mounted, self-contained and fully detachable Blizzard R290 condensing unit uses environmentally friendly, EPA-compliant R290 refrigerant with zero (0) Ozone Depletion Potential (ODP) and three (3) Global Warming Potential (GWP). Blizzard R290 is easily replaceable and requires no on-site brazing.

• Galvanized steel bottom and rear.
• Four 5" swivel casters with locks on front set.
• 16 gauge, high quality stainless steel worktop.
• 2.5" thick high density polyurethane insulation.
• Heavy duty stainless steel interior / exterior with rounded corners for a hazard-free workspace.

• Heavy duty stainless steel interior / exterior.
• 2.5" thick high density polyurethane insulation.
• High strength, recessed door and drawer handles.
• Self-closing door with adjustable torsion system for a positive seal.
• Thick gauge, stainless steel drawer frames with low-friction ball bearings.
• Snap-in magnetic door and drawer gaskets make cleaning and replacement an easy process.

• Height adjustable stainless steel clips.

• Multi-function digital controller with easy to read LED display.
• Audible overheat protection alarm for compressor and condenser coil.
• Factory preset temperature, 35°F. Temperature setting range from 33°F to 54°F.

• 3” swivel casters with locks.
• 3.5” - 6” height-adjustable and interchangeable legs.
• 4” high stainless steel backsplash for worktop application.