Everest Refrigeration EPPR1-D2 35.63'' 2 Drawer Counter Height Refrigerated Pizza Prep Table

Drawered Pizza Prep Table, one-section, 35-5/8"W, 9.0 cu. ft. capacity, self-contained side mounted refrigeration, stainless steel top with opening for (4) 1/3 size pans, (1) 1/2" thick insulated top lid, (2) heavy duty stainless steel drawers, 19-1/4" removable cutting board, digital controls with LED display, auto defrost, stainless steel interior, stainless steel front, top & sides, galvanized steel bottom & rear, (2) leg stabilizers, (4) 5" swivel casters (2 locking), R290 Hydrocarbon refrigerant, 1/3 HP, 115v/60/1-ph, 2.5 amps, cord, NEMA 5-15P, NSF, cETLus, ETL-Sanitation (drawer pans not included)

• Pre-wired and ready to plug, 115V/60Hz/1Ph, NEMA 5-15P.
• Full-length air duct system ensures optimal circulation of cold air.
• Large capacity, corrosion-resistant condenser and evaporator coils.
• Time-initiated and temperature-terminated auto defrost cycle for seamless operation.
• Pressure relief devices allow smooth access to cabinet interior when re-opening doors.
• Electronically commutated (ECM) fan motors achieve rapid cooling with less energy consumption.
• Self-maintaining, energy-efficient condensate drain pan requires no external drains or electric heaters.
• High performance, auto-reverse condenser fan motor supports compressor ventilation and condenser coil cleaning. Refer to owner’s manual for full maintenance instructions.
• Side mounted, self-contained and fully detachable Blizzard R290 condensing unit uses environmentally friendly, EPA-compliant R290 refrigerant with zero (0) Ozone Depletion Potential (ODP) and three (3) Global Warming Potential (GWP). Blizzard R290 is easily replaceable and requires no on-site brazing.

• Galvanized steel bottom and rear.
• 2.5" thick high density polyurethane insulation.
• 16 gauge, high quality stainless steel worktop, lid and hood.
• Four 5" swivel casters with locks on front set and two front leg stabilizers.
• Heavy duty stainless steel interior / exterior with rounded corners for a hazard-free workspace.

• Heavy duty stainless steel interior / exterior.
• 2.5" thick high density polyurethane insulation.
• Frame heaters prevent exterior moisture build up.
• High strength, recessed door and drawer handles.
• Self-closing door with adjustable torsion system for a positive seal.
• Thick gauge, stainless steel drawer frames with low-friction ball bearings.
• Snap-in magnetic door and drawer gaskets make cleaning and replacement an easy process.

• 19 1/4” deep cutting board is removable for ease of cleaning.
• NSF certified polycarbonate 6" deep pans (see table for size and quantity).
• 1/2” thick, foam insulated lid keeps top pan area cold and prevents moisture build-up.

• Height adjustable stainless steel clips.
• Epoxy coated, steel wire shelves for applicable models (see table for quantity).

• Multi-function digital controller with easy to read LED display.
• Audible overheat protection alarm for compressor and condenser coil.
• Factory preset temperature, 35°F. Temperature setting range from 33°F to 54°F.

• Additional shelving.
• 3” swivel casters with locks.
• NSF certified stainless steel double overshelf.
• 3.5” - 6” height-adjustable and interchangeable legs.